A-A-52446
e. Body sealer. The SMC material shall be compatible with body sealer. Sealer shall not contain any chlorofluorocarbon (CFC).
f. Finish color. Unless otherwise specified (see note b), the SMC molded part shall be integrally colored black.
g. Identification marking. Unless otherwise specified in the AED, identification and marking of the SMC molded parts shall be permanent and legible and shall include, as a minimum, the AED part number, the manufacturer’s CAGE code, and when specified, the molder’s identification marking (see Note b).
QUALITY ASSURANCE PROVISIONS
a. Responsibility for inspection. The contractor is responsible for the performance of all inspections (examinations and tests).
b. First article inspection. When specified (see note b), a first article sample shall be inspected to verify conformance to the salient characteristics in this CID. Approval of the first article sample by the Government shall to relieve the contractor of the obligation to supply items that are fully representative of those inspected as a first article sample.
c. Contractor certification. The contractor shall certify and maintain substantiating evidence that the product offered meets the salient characteristics of this commercial item description and that the product conforms to the producer’s own drawings, specifications, workmanship standards, and quality assurance practices. Items with known defects shall not be submitted for Government acceptance. The Government reserves the right to require proof of such conformance prior to the first delivery and thereafter as may be otherwise provided for under the provisions of the contract.
PRESERVATION, PACKAGING, PACKING, LABELING, AND MARKING
Preservation, packaging, packing, labeling, and marking for the desired level shall be as specified in the contract or order (see note b).
NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
a. Addresses for obtaining copies of referenced documents. Copies of ASTM D570 “Standard Test Method for Water Absorption of Plastics”; ASTM D638 “Test Method for Tensile Properties of Plastics”; and ASTM D790 Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials (Metric),” can be obtained from the American Society for Testing and Materials, 1916 Race Street, Philadelphia, PA 19103-1187.
b. Ordering data. Acquisition documents must specify the following:
1. Title, number, and date of this commercial item description.
2. Issue of DODISS to be cited in the solicitation and, if required, the specific issue of individual documents referenced.
3. AED and revision letter, and part number.
4. Molder’s identification marking, if required.
5. First Article, if required.
6. Selection of applicable level and packaging requirements.
7. Color, if other than as specified.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business