MIL-DTL-83054C
3.7.5 Sunshine. The baffle material shall be exposed to sunshine as specified (see 4.6.21), to
determine the loss of tensile strength due to radiation.
3.8 Dimensions and tolerances. Baffle and inerting material shall be in the following size buns:
Type I - 40x80x8 inches
Types II, III, V - 44x110x12 inches
Type IV - 44x110x8 inches
3.8.1 Optional bun sizes. Optional bun sizes of the baffle material may also be produced by the
manufacturer provided the following sizes are included: 40x80x8 inch size for types II, III, IV, and V,
44x110x8 inch size for types I, II, III, and IV. Production tolerance limits on bun sizes shall be as
follows:
a. Thickness +1/8 inch
b. Length and width +1,-0 inch
3.9 Identification of product. The baffle material shall be sealed in a clean polyethylene bag as it comes
off the production tine. A labeled card shall be provided inside the bag which clearly identifies the
manufacturer's part number, date of manufacture, production run number, loaf, and bun number. Where
applicable, the government contract or order number shall be included. There shall be no color coding
or marking on the bun surface.
3.10 Workmanship. The baffle material shall be fabricated in accordance with high-grade
manufacturing practices covering this type of material. The baffle material shall be suitable for its
intended use and free of defects which may affect its performance. It shall be of a uniform color and
free from excessive voids.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified as
follows:
a. Qualification inspection (see 4.4).
b. Conformance inspection (see 4.5).
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business