MIL-DTL-83054C
4.4.1.3 For production and lot testing. For production and lot testing, the test section shall consist of a
section approximately 15 inches long by the normal bun height and width which has been processed
along with normal production material. Location of the specific test samples within the test section shall
be in accordance with the guidelines specified (see 4.6). Specimen measurements shall be in
accordance with ASTM-D3574.
4.4.1.4 Quantity of specimens. Unless otherwise specified herein, three specimens per sample shall be
tested. The value reported shall be the average of those observed. If any value deviates more than
20% from the average value, two additional specimens shall be tested and the average for all five values
shall be reported.
4.4.3 Qualification inspection. The qualification inspection shall consist of all the tests specified (see
4.6).
4.5 Conformance inspections. Quality conformance inspections shall consist of the following tests:
a. Production tests (see 4.5.1)
b. Lot tests (see 4.5.2)
c. Process control tests (see 4.5.3)
d. Examination of product (see 4.6.1)
4.5.1 Production tests. Production tests shall be conducted on each run of material produced (see
6.3.1). The minimum testing frequency shall be every 300 linear feet of types I, II, and III baffle
material and every 180 linear feet of types IV and V baffle material. The following production tests shall
be conducted:
a. Color test (see 4.6.2)
b. Density test (see 4.6.3)
c. Porosity (air pressure drop) test (see 4.6.4)
d. Tensile strength and elongation tests (see 4.6.5)
e. Entrained solid contamination tests (see 4.6.15)
f. Steam autoclave exposure test (see 4.6.16)
The steam autoclave exposure test specified (see4.6.16) shall be conducted once for each machine run
to verify the hydrolytic stability characteristics of the material.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business