MIL-P-46067B(MR)
4.2 Sampling for inspection and acceptance. Sampling for inspection and acceptance shall be performed in accordance with the provisions set forth in MIL-STD-105, except where otherwise indicated. For purposes of sampling, an inspection lot for examination and tests shall consist of all material of the same type submitted for delivery at one time.
4.2.1 Inspection of materials and components. In accordance with 4.1 above, the supplier is responsible for insuring that materials and components used were manufactured, examined, and tested in accordance with the requirements of this specification and, to the extent specified, of all referenced subsidiary specifications and standards. In the event of conflict, this specification shall govern. A supplier's certification of compliance
with 3.1 and 3.3 shall be furnished.
4.2.2 Inspection of material.
4.2.2.1 Examination of the material. Examination of the material shall be in accordance with the classification of defects, inspection levels and acceptable quality levels (AQLs) set forth below. The lot size, for purpose of determining the sample size in accordance with MIL-STD-105, shall be expressed in the units of 22.6 kg (50 pounds) for examination in 4.4.2.1.1, and in units of shipping containers for examination in 4.4.2.1.2.
4.2.2.1.1 Examination of the material for defects in appearance and workmanship. The sample unit for this examination, specified in table II, shall be approximately one pound selected just prior to the closure operation.
6
Source: https://assist.dla.mil -- Downloaded:
Check the source to verify that this is the current version before use.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business