MIL-P-46067B(MR)
5.2 Packing. Packing shall be level A, B, or C as specified (see 6.2).
5.2.1 Level A. Resin packaged in containers conforming to PPP-C-96 shall be packed in accordance with the overseas requirements of the appendix thereto. Resin packaged in containers conforming to PPP-P-704, PPP-P-705 or PPP-D-729 require no overpacking. When specified (see 6.2), 5 gallon pails and 16 gallon drums shall be palletized in accordance with MIL-STD-147.
5.2.2 Level B. Resin packaged in containers conforming to PPP-C-96 shall be packed in accordance with the domestic requirements of the appendix thereto. Resin packaged in containers conforming to PPP-P-704, PPP-P-705 or PPP-D-729 require no overpacking. When specified (see 6.2), 5 gallon pails and 16 gallon drums shall be palletized in accordance with MIL-STD-147.
5.2.3 Level C. The cans, pails or drums shall be packed in accordance with commercial practice adequate to ensure acceptance and delivery by the carrier for the mode of transportation employed. Containers shall comply
with the requirements of the Uniform Freight Classification Rules or National Motor Freight Classification Rules, as applicable to the mode of transportation.
5.3 Marking. Interior packages, exterior shipping containers and palletized unit loads shall be marked in accordance with MIL-STD-129.
5.3.1 Hazardous chemicals. All packaged units of hazardous chemicals shall have affixed thereto such warning labels and markings as may be required by the Department of Transportation CFR, Title 49, Part 171-189 and the American National Standards Institute ANSI K 68.1.
5.3.2 Warning markings. All packaged units shall be marked: Warning: USE WITH ADEQUATE VENTILATION - MAY BE FLAMMABLE -
The solvents contained in this compound may have flash
points well below prevailing room temperatures. Do not
heat by, or use near, and open flame. Heat preferably by
means of a steam coil or other nonflame-producing heat
source.
WARNING: Catalyst promoters, and solvent to be used with this compound should be stored in original tight containers isolated from one another in cool locations. Never permit a catalyst to come in contact with any component except the base compound.
11
Source: https://assist.dla.mil -- Downloaded:
Check the source to verify that this is the current version before use.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business