MIL-P-85878
4.4 Quality conformance inspection. Quality conformance inspection shall consist of all examinations and tests specified in 4.5 and 4.7.
4.4.1 Inspection lot. A lot shall consist of all material of the same type submitted for acceptance and delivery at one time. The lot size shall be as specified in units of sheets and units of shipping containers, as applicable.
4.4.2 Samples for quality conformance tests. The sample unit for each lot shall be as specified in 4.4.2.1,
4.4.3.3, and 4.4.2.3, The inspection level for determining the sample size shall be in accordance with
MIL-STD-105 as specified in table I. . The acceptable quality level (AQL) shall be as specified in table I.
TABLE I. Inspection Level and AQL
|
Examination or test |
Examination or test reference |
Inspection level |
AQL |
Appearance, workmanship and identification |
4.5.1 |
I |
2.5 |
Dimensional |
4.5.2 |
I |
4.0 |
Preparation for delivery |
4.5.3 |
S-2 |
4.0 |
End item tests |
4.7 |
S-1 |
6.5 |
4.4.2.1 Sampling for examination of end item defects. The sample unit for examination of the end item defects shall be one sheet. The samples may be selected before application of adhering cover material and shall be subjected to the examination specified in table II and III
4.4.2.2 Sampling for preparation for delivery. The sample unit for examination for determining compliance with the requirements of section 5 shall be one fully packed shipping container, prior to sealing. Defects shall be scored in accordance with table IV.
4.4.2.3 Sampling for testing of the end item. The sample unit for testing of the end item shall be one sheet or
4 square feet, having a minimum dimension of 6 inches. If less than a whole sheet is used, not more than one sample shall be taken from the same sheet.
4.5 Examination
4.5.1 Appearance and workmanship. Samples shall be examined for the defects specified in table II.
4.5.2 Dimensional. Samples shall be examined for the defects specified in table III.
4.5.3 Preparation for delivery. Samples shall be examined to determine conformance to the requirements of section 5 and the existence of defects specified in table IV.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business