MIL-DTL-62474F
3.5 Workmanship. The plastic laminates shall satisfy visual acceptance Level I of
ASTM D2563 for the following defects:
a.
Blister
b.
Burned
c.
Cracked
d.
Crack, surface
e.
Crazing
f.
Delamination, edge
g.
Delamination, internal
h.
Dry spot
i.
Lack of fillout
j.
Wrinkles.
Fabric reinforcement layers shall not have pleats, wrinkles, or creases. Fabric layers shall be free
of tears, reasonably straight, and perpendicular warp-to-fill. Edges of the finished laminate shall
be free of frayed edges (see 4.3.4).
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are
classified as follows:
a. First article inspection (see 4.2).
b. Conformance inspections (see 4.3).
1. Conformance examination (see 4.3.2).
2. In-process examination (see 4.3.3).
3. Control test (see 4.3.4).
4.2 First article inspection. The contractor shall supply two samples for first article
inspection. Two samples shall measure 20 in. by 20 in. (508 mm by 508 mm) by contract
designated plies. All samples shall be produced with materials and processes proposed for use
on production laminates. Inspection shall be carried out by the contractor under Government
surveillance. Inspection shall consist of all quality conformance and control tests. Upon
successful completion of the quality conformance and control test, the samples shall be
forwarded to the test site identified by the procuring activity (see 6.2). The test samples shall be
adequately identified as to the contractor, contract number, manufacturer, and date. The ballistic
test samples will be tested by the Government for the requirements of 3.4.3 in accordance with
4.3.5.1, except that for each ballistic sample must meet the V50 protection ballistic limit. Any
changes or deviations of production units from the first article sample shall be subject to the
approval of the contracting officer.
4.3 Conformance inspection. Conformance inspection shall include the examination of
4.3.2 & 4.3.3 and the control tests of 4.3.4 thru 4.3.4.3 and 4.3.5 (see table IV).
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business